Ultimaker

  • DRUKARKI 3D
    • ULTIMAKER S5
    • ULTIMAKER 3
    • ULTIMAKER 2+
    • ULTIMAKER ORIGINAL+
    • PORÓWNANIE DRUKAREK
  • MATERIAŁY
    • PLA
    • Tough PLA
    • ABS
    • CPE i CPE+
    • PP (Polipropylen)
    • PC (Poliwęglan)
    • Nylon
    • TPU 95A
    • PVAPODPOROWY
    • BreakawayPODPOROWY
  • OPROGRAMOWANIE
    • ULTIMAKER CURA4.1
    • ULTIMAKER APPMOBILNA
    • ULTIMAKER 3 APPMOBILNA
  • AKCESORIA
    • AKCESORIA I DODATKI
    • CZĘŚCI ZAMIENNE
  • GDZIE KUPIĆ
  • POMOC
  • NEWS
ZAPYTAJ O
OFERTĘ

There was an error with the safety circuit.

Rozwiązywanie problemów

  • Komunikaty błędów
    • An unspecified error has occurred
    • Max temp. error on PrintCore
    • Min temp. error on PrintCore
    • PrintCore taking too long to warm up
    • Max temp. error on the build plate sensor
    • Heater error on PrintCore
    • The Z axis is stuck or the limit switch is broken
    • The X or Y axis is stuck or the limit switch is broken.
    • There is a communication error with the print head.
    • There is an I2C communication error.
    • There was an error with the safety circuit.
    • There was a sensor error within the print head.
    • Active leveling correction failed.
    • An incorrect print temperature is specified.
    • An incorrect build plate temperature is specified.
    • The motion controller failed to be updated.
    • This print job is not suitable for this printer.
  1. Home
  2. Tech Zone
  3. Rozwiązywanie problemów
  4. Komunikaty błędów
  5. There was an error with the safety circuit.

There was an error with the safety circuit.

Błąd obwodu bezpieczeństwa.

Pojawienie się tego błędu oznacza, że aktywował się obwód bezpieczeństwa płyty głównej elektroniki drukarki który zabezpiecza ją przed uszkodzeniem elektrycznym.

Skontaktuj się z lokalnym serwisem aby uzyskać pomoc.

Nadal coś jest niejasne? Jak możemy Ci pomóc?
Zaktualizowano 4 czerwca 2019

Doc navigation

← There is an I2C communication error.There was a sensor error within the print head. →
Czy ten artykuł był pomocny? Tak Nie

Jak możemy Ci pomóc?

  • DRUKARKI 3D ULTIMAKER
  • MATERIAŁY DO DRUKU 3D
  • OPROGRAMOWANIE
  • AKCESORIA I DODATKI
  • GDZIE KUPIĆ
  • NEWS

DYSTRYBUCJA W POLSCE

get3D Sp. z o.o.
90-009 Łódź
Sienkiewicza 59
[email protected]
tel.: +48 42 630 50 50

Ultimaker

© 2015 - 2018 get3D Sp. z o.o. | Wszystkie prawa zastrzeżone.

TOP